07Additional information
Problem | Remedy |
Can’t operate the remote | • Replace the battery (refer to page 7). |
control. | • Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel |
| (refer to page 14). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
|
|
The display is dark or off. | • Press DIMMER on the remote control repeatedly to return to the default. |
|
|
XM radio messages
Message | Cause | Action |
ANTENNA | The XM antenna is not connected. | Check that the XM antenna cable is attached |
|
| securely. |
|
|
|
ANT ERR | A | Make sure that there is nothing unusual with |
| surrounding antenna cable. | the antenna or antenna cable. Switch the |
|
| power off then back on again. |
|
|
|
UPDATING | The radio is being updated with the latest | Wait until the encryption code has been |
| encryption code. | updated. Channels 00 and 01 should function |
|
| normally. |
|
|
|
NO SIGNAL | The XM signal is too weak at the current | n/a |
| location. |
|
|
|
|
LOADING | The receiver is acquiring audio or program | Wait until the information has been received. |
| information. |
|
|
|
|
OFF AIR | The channel currently selected has stopped | Select another channel. |
| broadcasting. |
|
|
|
|
CH– – – | You have selected a channel that does not | The receiver will automatically switch to |
| exist, or that you have not subscribed to. | channel 001 (or the last selected channel). |
|
|
|
| There is no artist name/feature, song/ | No action needed. |
| program title, or channel category associated |
|
| with the channel at this time. |
|
|
|
|
Specifications
Amplifier section
Power output specification is for when power supply is 120 V.
•Continuous power output (both channels driven at 20 Hz to 20 kHz)**
THD 0.2 %, 4 Ω . . . . . . . . . . . . . . . . . 70 W + 70 W THD 0.2 %, 8 Ω . . . . . . . . . . . . . . . . . 55 W + 55 W
•FTC Continuous power output (both channels driven at 1 kHz)
THD 1.0 %, 4 Ω. . . . . . . . . . . . . . . . . 65 W + 65 W THD 1.0 %, 8 Ω. . . . . . . . . . . . . . . . . 55 W + 55 W
•Total harmonic distortion**
20 Hz to 20 kHz, 25 W, 8 Ω . . . . . . . . . . . . 0.05 %*
*Measured with DIRECT button switched on.
**Measured by Audio Spectrum Analyzer
26
En