WARNING:
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230V or 120V) written on the rear panel.
WARNING: No naked flame sources, such as lighted candle, should be placed on the apparatus. If naked flame sources accidentally fall down, fire spread over the apparatus then may cause fire.
This product is for general household purposes. Any failure due to use for other than household purposes (such as
K041_En
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Operating Environment
Operating environment temperature and humidity: +5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH (cooling vents not blocked)
Do not install in the following locations
•Location exposed to direct sunlight or strong artificial light
•Location exposed to high humidity, or poorly
ventilated location
When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.
H048_En
This product includes FontAvenue® fonts licenced by NEC corporation. FontAvenue is a registered trademark of NEC Corporation.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.
IMPORTANT | The | Do not connect either wire to the earth terminal of a | ||
not be inserted into any 13 amp socket as this can | three pin plug. | |||
result in electric shock. The plug or adaptor or the | NOTE | |||
FOR USE IN THE UNITED | distribution panel should be provided with 5 A fuse. | |||
As the colours of the wires in the mains lead of this | After replacing or changing a fuse, the fuse cover in | |||
KINGDOM | ||||
appliance may not correspond with coloured | the plug must be replaced with a fuse cover which | |||
The wires in this mains lead are coloured in | markings identifying the terminals in your plug, | corresponds to the colour of the insert in the base | ||
accordance with the following code: | proceed as follows ; | of the plug or the word that is embossed on the | ||
Blue | : Neutral | The wire which is coloured blue must be connected | base of the plug, and the appliance must not be | |
Brown | : Live | to the terminal which is marked with the letter N or | used without a fuse cover. If lost replacement fuse | |
If the plug provided is unsuitable for your socket | coloured black. | covers can be obtained from your dealer. | ||
outlets, the plug must be cut off and a suitable plug | The wire which is coloured brown must be | Only 5 A fuses approved by B.S.I or A.S.T.A to | ||
fitted. |
| connected to the terminal which is marked with the | B.S.1362 should be used. | |
|
| letter L or coloured red. | ||
