Pioneer VSX-1022-K, VSX-822-K OFF, AUTO, SB CH, DIMMER, 15MUTE, 16DISP, LEV +/–, VOL +/–, CAUTION, MIDNIGHT, MIDNIGHT, SPEAKERS, 11SOURCE, SIGNAL SEL, S.RETRIEVER, 13+Favorite

1 Controls and displays

10 Number buttons and other component controls

Use the number buttons to directly select a radio frequency (page 32) or the tracks on a CD, etc. There are other buttons that can be accessed after RECEIVER is pressed. (For example MIDNIGHT, etc.)

EQ – Press to switch on/off Acoustic Calibration EQ setting (page 34).

PHASE – Press to switch on/off Phase Control (page 35).

SIGNAL SEL – Press to select the audio input signal of the component to play back (page 25).

S.RETRIEVER – Press to restore CD quality sound to compressed audio sources (page 34).

SB CH – Press to select ON, AUTO or OFF the surround back channel (page 35).

CH SELECT – Press repeatedly to select a channel, then use LEV +/– to adjust the level (page 48).

LEV +/– – Use to adjust the channel level.

MIDNIGHT – Switches to Midnight or Loudness listening (page 36).

SPEAKERS – See Switching the speaker terminal on page 14.

DIMMER – Dims or brightens the display. The brightness can be controlled in four steps.

11SOURCE

Press to turn on/off other components connected to the receiver (page 54).

12 TV CONTROL buttons

These buttons are dedicated to control the TV assigned to the TV button. Thus if you only have one TV to hook up to this system assign it to the TV button (page 55).

– Use to turn on/off the power of the TV. INPUT – Use to select the TV input signal. CH +/– – Use to select channels.

VOL +/– – Use to adjust the volume on your TV.

13+Favorite

Press while a song is being played back or stopped. The selected song is then registered in the Favorites folder (page 40).

14 VOLUME +/–

Use to set the listening volume.

15MUTE

Mutes/unmutes the sound.

16DISP

Switches the display of this unit. The listening mode, sound volume, Speaker System (VSX-1022)/Pre Out (VSX-822)setting or input name can be checked by selecting an input source.

•The Speaker System/Pre Out setting may or may not be displayed, depending on the input source you have selected.

Loading the batteries

The batteries included with the unit are to check initial operations; they may not last over a long period. We recommend using alkaline batteries that have a longer life.

CAUTION

•Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:

-Never use new and old batteries together.

-Insert the plus and minus sides of the batteries properly according to the marks in the battery case.

-Batteries with the same shape may have different voltages. Do not use different batteries together.

-When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

-Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries.

10

Operating range of remote control

The remote control may not work properly if:

•There are obstacles between the remote control and the receiver’s remote sensor.

•Direct sunlight or fluorescent light is shining onto the remote sensor.

•The receiver is located near a device that is emitting infrared rays.

•The receiver is operated simultaneously with another infrared remote control unit.

30° 30°

7 m (23 ft.)