09Controlling the rest of your system
Chapter 9:
Controlling the rest of your system
Operating multiple receivers
Up to four receivers can be operated discretely using this receiver's remote control when using multiple receivers, provided they are of the same model as this receiver. The receiver to be operated is switched by inputting the preset code to set the remote control setting.
•Set the remote modes on the receivers before using this function (see Remote Control Mode Setup on page 87).
1Press and hold R.SETUP, then press “4” for three seconds.
•For greater convenience, assign the TV connected to the MONITOR OUT terminal to the TV CTRL button, and assign your satellite/cable receiver or
•Devices may be assigned to the following input function buttons.
RECEIVER MULTI | SOURCE | |
| OPERATION |
|
| R.SETUP |
|
BD | DVD DVR/BDR | HDMI |
The LED flashes continuously.
• To cancel the preset setup mode press R.SETUP.
2Press the number button for the receiver (“Receiver 1” to “Receiver 4”) you wish to operate.
For example, to operate “Receiver 2”, press “2”.
If the LED lights for one second, the setting has been successfully completed.
When the preset code is input, the LED flashes three times to indicate that the setting has failed.
Setting the remote to control other components
Most components can be assigned to one of the input function buttons (such as DVD or CD) using the component’s manufacturer preset code stored in the remote.
However, there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still teach the remote individual commands from another remote control (see Programming signals from other remote controls on page 67).
Note
•You can cancel or exit any of the steps by pressing R.SETUP.
•After one minute of inactivity, the remote automatically exits the operation.
TV | CD | NET RADIO ADAPTER | |
iPod USB TUNER | SIRIUS | XM | |
INPUT SELECT | TV CTRL RECEIVER | ||
Selecting preset codes directly
1Press and hold R.SETUP, then press “1” for three seconds.
The LED flashes continuously.
•To cancel the preset setup mode press R.SETUP.
2Press the input function button for the component you want to control.
When assigning preset codes to TV CONTROL, press TV CTRL here.
The LED blinks once and flashes continuously.
3Use the number buttons to enter the
See Preset code list on page 104.
If the LED lights for one second, the setting has been successfully completed.
When the preset code is fully input, the LED flashes three times to indicate that the setting has failed. If this happens, enter the
4Repeat steps 2 through 3 for the other components you want to control.
To try out the remote control, switch the component on or off (into standby) by pressing SOURCE. If it doesn’t seem to work, select the next code from the list (if there is one).
5Press R.SETUP to exit the preset setup mode.
66
En