Additional Information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
Symptom |
|
| Cause |
| Remedy | |
The power does not | • | The power plug is disconnected. | • Connect the power plug to the wall | |||
turn ON. |
|
|
|
|
| outlet. |
|
|
| • The protection circuit may have been | • Disconnect the power plug from the | ||
|
|
|
| activated. |
| outlet, and insert again. |
The unit | does | not | • | Static electricity caused by dry air. | • Disconnect the power plug from the | |
respond | when | the |
|
|
| outlet, and insert again. |
buttons are pressed. |
|
|
|
| ||
|
|
|
| |||
No sound is output | • | Improper connections. | • Make sure the component is | |||
when a function is |
|
|
| connected correctly (refer to pages 8 | ||
selected. |
|
|
|
|
| to 12). |
|
|
| • | Sound is muted. | • Press MUTING on the remote | |
|
|
|
|
|
| control. |
|
|
| • The volume is turned down. | • | Adjust MASTER VOLUME. | |
|
|
| • The MONITOR is ON. | • | Press the MONITOR button. | |
|
|
| • Speakers are turned OFF. | • Press SPEAKERS to select the speakers | ||
|
|
|
|
|
| you connected. |
|
|
|
| |||
No image is output | • | Improper connections. | • Make sure the component is | |||
when a function is |
|
|
| connected correctly (refer to pages | ||
selected. |
|
|
|
|
| |
|
|
| • | The input source is not properly | • Press the correct function button. | |
|
|
|
| selected. |
|
|
Considerable noise in radio broadcasts.
• | Incorrect frequency. | • | Tune in the correct frequency. | ||
• The antenna is not connected. | • | Connect the antenna (refer to page 8). | |||
• 2RF | • | Route 2RF | |||
| near the antenna terminals and |
| away from the antenna terminals and | ||
| wires. |
| wires. | ||
FM broadcasts |
|
|
|
| |
|
| • | Fully extend the FM wire antenna, | ||
• The FM antenna is not fully extended | |||||
| or is poorly positioned. |
| position for best reception, and | ||
|
|
|
|
| secure to a wall. |
• | Weak radio signals. | • | Connect an outdoor FM antenna | ||
|
|
|
|
| (refer to page 8). |
AM broadcasts |
|
|
| ||
| • | Adjust the direction and position for | |||
• The AM antenna is poorly positioned. | |||||
• | Weak radio signals. |
| best reception. | ||
|
|
|
| • | Connect an additional internal or |
• Interference cause by other |
| external AM antenna (refer to page 8). | |||
| equipment (fluorescent lamp, motor, | • | Turn off the equipment causing the | ||
| etc.). |
| noise or move it away from the | ||
|
|
|
|
| receiver. |
• Place the antenna farther away from the equipment causing the noise.
41