B700 Installation Instructions
6. Install the Stacker
Slide the stacker up against the right side of the meter and posi- tion it as shown. The stacker sits next to the meter. It's not physi- cally connected to it. In this posi- tion, the stacker can handle enve- lopes up to #10. If you're using longer envelopes, move the stacker to the right to accommodate them.
7. Make a Test Imprint
a.The display normally shows the default postage amount
shown at the right. This is usually the rate for first class letter mail weighing up to one ounce.
b.At the keyboard type a 0 (zero) and then Enter.
c.The display now shows zero as the postage value. The
meter is ready to use when the amount you entered is bracketed by three bars as shown.
d.Place a sample envelope on the
feed deck face |
|
up and push it |
|
against the rear | Insert Envelope |
wall of the meter | |
(1). | from Left |
e. Slide the enve- | 2 |
lope to the right | |
(2) until its lead | 1 |
| |
edge touches the | Push Envelope up |
trip mark on the | to Mark on Deck |
feed deck. |
|
f.The meter will sense the pres-
ence of the envelope, convey it through the print area and into the stacker. The meter impression should look
Page 8
