Planar C3215 user manual Powering Up the Clean Screen II PC, Power On, Setup F2, Driver Overview

Powering Up the Clean Screen II PC

Power-on

Light

Hard

Disk

Figure 15

Power On

Once the keyboard, mouse, power, and all peripherals have been connected, use the power switch located beneath the power-on indicator to power up the unit.

Always power down the unit before you connect or disconnect any peripheral.

Setup (<F2>)

When the screen first writes, press <F2> on the keyboard to enter the CMOS Setup menu. Refer to the next chapter for details.

Driver Overview

If you ordered the Clean Screen II PC with an operating system pre-loaded, then the display, network, and touch drivers will already be loaded on the hard disk. Otherwise you will need to check the floppy disks that came with the IS Manager’s Kit for the appropriate drivers. You will find documentation and instructions in the Readme files stored on the disks.

Brightness Control

Display brightness can be controlled either by a hot key sequence of control–alt–F1to increase brightness, or control–alt–F2to decrease brightness. Some operating systems may provide addi- tional brightness adjustment.

Chapter Four: System Setup 15