Planar C3215 Chapter Three Hardware Installation and Replacement, Removing the Back Housing

Chapter Three: Hardware Installation and Replacement

This chapter refers to installing or replacing options within the Clean Screen II itself. Instructions on installing the Clean Screen II onto a standard Planar mounting option will come with the mounting equipment itself.

Removing the Back Housing

Twelve T25 Torx screws

Four holes for standard

Planar mounting options (10⁄32)

Three T20 Torx screws

Figure 8

Power down unit first and disconnect it from the power source.

1.Power down unit first and disconnect it from the power source.

2.Use a static-free workstation.

3.Place Clean Screen II face down on a secure flat surface, using a cloth or other non-abrasive material to protect the display.

4.Remove the twelve attachment screws from the back housing using a T25 torx driver.

5.Remove the three attachment screws from the back housing located near the connector ports using a T20 torx driver.

6.Remove the back panel itself by gently lifting the bottom back edge first.

6Planar Clean Screen II PC User’s Manual