Connecting the Display (Figure 1.1)
To set up this display, please refer to the following figure and procedures.
1.Be sure all equipment is off.
2.Connect the DC adapter to the power connector on the monitor and the other end to the power cord and the power cord into an electrical outlet.
3.Connect the VGA signal cable from the display’s VGA input connector to the VGA port connector of your host computer and tighten the thumb‐screws (1.1).
4.Power on the display and then power on your host computer.
Notice: To ensure the LCD display works well with your computer, configure the display mode of your graphic card, less than or equal to 1024 x 768 resolution and make sure the timing of the display mode is compatible with the LCD panel. “Video Modes” of this LCD panel are listed in the appendices for your reference.
Figure 1.1
LC1503R/LC1503R‐C User’s Guide | 11 |
