Content Management

Please consult the software documentation for information specific to your management solution.

Troubleshooting

Why is there no video output on composite video connectors?

The player outputs video over HDMI and VGA by default. To switch to composite video output, connect a HDMI or VGA display, then select PAL or NTSC output from the menu system (see System setup).

If both Ethernet & Wi-Fi are available, which connection will take priority?

If both connections are available, Ethernet will take priority for data transfer. When Ethernet is not available or disconnected, system will try to use Wi-Fi connection.

How do I remove an inserted CF card?

You can install a CF card to replace the 4GB internal memory. The card slot is located behind a metal plate (the CF card cover/remover). To remove an inserted CF card, remove the screw and use the CF card

cover/remover’s metal hooks to pull out the card.

Reset player to factory defaults

If modifying settings cause unintended results or if you have forgotten your password please reset the player. All stored content will also be removed.

1.Disconnect power cable from the player unit

2.Press and hold the RESET button

3.Connect the power cable while holding the RESET button until status light flashes (about 15 seconds)

4.Please wait while the system drive is being formatted

020-1194-00A

Page 4
Image 4
Planar MP-3450 quick start Content Management, Troubleshooting