Chapter 2 Using
are shown below.
|
| LAN Port |
| WAN Port |
|
|
|
|
|
|
|
| IP address | 192.168.1.254 |
| The Bridge function is |
|
|
|
| enabled by default. |
| |
|
|
|
|
| |
| Subnet Mask | 255.255.255.0 |
|
|
|
|
|
|
|
|
|
DHCP server | Enabled |
|
|
| |
|
|
|
| ||
function |
|
|
|
| |
|
|
|
|
| |
IP addresses for | 100 IP addresses continuing from |
|
|
| |
distribution to PCs | 192.168.1.1 through 192.168.1.100 |
|
|
| |
|
| (Actually, it can support up to 253 |
|
|
|
|
| users.) |
|
|
|
|
|
|
|
|
|
3.5 Information from the ISP
Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or DHCP client.
Gather the information as illustrated in the following table and keep it for reference.
Service Type | Need NAT / | Mode | Data needed | |
IP Sharing? | Selection | |||
|
| |||
RFC1483 |
|
| wVPI/VCI of WAN | |
|
| wIP address /subnet mask of WAN | ||
Routed and the | No | Router | ||
wThe computers are set the fixed | ||||
static IP address |
|
| ||
|
| assigned IP address | ||
|
|
| ||
RFC1483 Bridge |
|
| wVPI/VCI of WAN | |
|
| wPPPoE software installed on PC | ||
mode plus | No | Bridge | ||
wuser's name & password for | ||||
PPPoE |
|
| ||
|
| PPPoE | ||
|
|
| ||
RFC1483 |
|
| wVPI/VCI of WAN | |
Routed and the | Yes | NAT | ||
wIP address /subnet mask of WAN | ||||
global IP address |
|
| ||
|
|
| ||
RFC1483 Bridge | Yes | NAT2 | wVPI/VCI of WAN | |
and the global IP | wIP address /subnet mask /Gateway | |||
address |
|
| of WAN | |
RFC1483 Bridge | Yes | PPPoE+NAT | wVPI/VCI of WAN | |
mode plus | wuser's name & password for | |||
PPPoE |
|
| PPPoE | |
|
|
| wVPI/VCI of WAN | |
RFC2364 mode | Yes | PPPoA+NAT | wuser's name & password for | |
|
|
| PPPoA | |
RFC1483Bridge | Yes | DHCPc + NAT | wVPI/VCI of WAN | |
& DHCP client |
|
|
| |
|
|
|
|
15