Chapter 3
Initial Setup | 3 |
Preparation |
The initial setup of
∙Your PC can establish a physical connection to the Internet Camera. The PC and the Internet Camera must be directly connected (using the LAN port on the Inter- net Camera) or on the same LAN segment. That is, the PC must be configured to an IP address and subnet mask in 192.168.0.x segment. For example: IP:
192.168.0.2, subnet mask: 255.255.255.0.
∙The Internet Camera must be installed and powered ON.
∙If the Internet Camera's default IP Address (192.168.0.20) is already used by another device, the other device must be turned OFF until the Internet Camera is allocated a new IP Address during configuration.
Procedures
1.Insert the
2. Click on Setup Wizard hyperlink to activate the initial setup.
If the above screen is not shown, you can start the installation as follows.
•Click on Start Menu/ Run.
•Enter “D:\Utility\wizard.exe” in the appeared box, where “D” is the letter of your
•Click on “OK” button.
3.Once the wizard is activated, it would search available camera automatically.
7