3.External Microphone

Connect a microphone to the IP camera.

4.SD Card Slot

User can insert a micro SD card into this slot for event recording.

5.RJ-45 LAN Socket

The LAN socket is a RJ-45 connector for connections to 10/100Base-TX Fast Ethernet cabling. This Ethernet port built N-Way protocol can detect or negotiate the transmission speed of the network automatically. Please use CAT-5 cable to connect the IP camera to a 100Mbps Fast Ethernet network switch or hub.

6.Factory Default Reset

This button is used to restore the all factory default settings. Sometimes restarting the device will make the system back to a normal state. However, if the system still got problems after restart, user can restore the factory default settings and install it again.

Restore the device:

a. Insert the paper clip or other tool and press and hold the button down continuously.

b. Hold it at least 5 seconds and release the tool. Then the device has been restored to default settings and reboot again.

7.DI/DO Connector

The Camera provides a terminal block with 4 pins of connectors for DI and DO. Please refer to the user’s manual for more information. The pin 1 is located at the right side of terminal block from rear view.

2.7.3 ICA-H610 Installation

Ceiling Mount

1. Fix the IP camera to L-type bracket with the two supplied screws.

27