Plantronics CS50 Usage Instructions, Adjustments, Diagram Key, Base Unit, Headset, Installation

EN

USAGE INSTRUCTIONS

	DIAGRAM KEY
Base Unit		12 Headset Docking Cradle
1	Tx Slide Switch (A-D)	13 Charge contacts
	(Speak Volume Master)	14 Charge Indicator
2	Rx Slide Switch (1-4)	15 Talk Indicator
	(Speak Volume Master)	16 Power Indicator
3	Speak Volume Adjust UP
		17 Handset Lifter (optional)
4	Speak Volume Adjust
		Headset
	DOWN
		18 Microphone
5	IntelliStandTM Switch
	ON/OFF	19 Speaker
		20 Talk Button
6	Configuration Dial
		21 Listen Volume Adjust
7	AC Power Adapter
		UP/DOWN
8	AC Power Adapter Port
		22 Headset Mute Switch
9	Handset Cable Port
		23 On-line Indicator
10 Telephone Cable Port

You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.

Tip: By selecting Handset mode after completing your call, you will conserve the headset battery power and extend the remaining available talktime. You can achieve this by pressing the Talk Button (20) immediately on conclusion of the call.

Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section “Making a call using the Lifter” on page 9.

RECEIVING A CALL USING YOUR HEADSET

When your telephone rings take the handset off the hook. Ensure that your CS50 Wireless Headset System is already in Headset mode. You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.

Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section “Receiving a call using the lifter”

EN

11 Accessory Port

24 Charge contacts

25 Battery Door

on page 9.

ADJUSTMENTS

INSTALLATION

Please install the CS50 Wireless Headset System in accordance with the instructions detailed in the Quick Start Guide.

HEADSET/HANDSET MODE

Pressing the Talk Button (20) on the Headset selects Headset mode. The Talk Indicator (15) on the base unit will illuminate and the On-Line Indicator (23) on the headset will flash when in Headset mode. Both of the indicators are extinguished when in Handset mode.

PLACING A CALL USING YOUR HEADSET

To place a call using the headset, the system must be in Headset mode. Take the handset off the hook and dial in the normal way.

PLACING AND RECEIVING A CALL USING THE HANDSET

In Handset mode the telephone can be used to make and receive calls in the normal way.

OUT OF RANGE WARNING

As you walk away from the base unit you will eventually reach the system operating range limit. When in Headset mode a warning alert of two beeps will sound in the headset shortly before you meet the range limit.

On hearing this alert you should walk closer to the base unit to ensure call quality is maintained.

6 7