EN
If you remain out of range for more than 15 minutes the system will drop the call permanently. If using a Plantronics Handset Lifter the handset will be replaced and the call terminated.
LOW BATTERY WARNING
When the headset battery is running low (approximately 5 minutes talk time remaining), an audible warning will be heard through the headset as a single beep repeating every 10 seconds. Soon after hearing this warning, you should recharge the headset.
RECHARGING THE HEADSET
To recharge the headset, place it into the Headset Docking Cradle
(12)in the base unit. During charging, the Charge Indicator (14) on the base unit will flash.
When the headset is fully charged, the Charge Indicator (14) on the base unit will stop flashing and remain illuminated.
A completely depleted headset requires a minimum charge time of 1hr before it should be used and 3 hours to fully charge.
REPLACING THE HEADSET BATTERY
Should it be necessary to replace the headset battery at anytime please refer to the diagrams on page 6.
OPERATION WITH THE HANDSET LIFTER ACCESSORY
The Plantronics Handset Lifter (17) is an accessory that can be purchased for use with the CS50 Wireless Headset System. It has two functions:
1.To automatically notify you when an incoming call is detected even when you are away from your desk.
2.To lift the telephone handset from its cradle at your command even when you are away from your desk.
The installation of the Handset Lifter (17) is described in the user guide that is supplied with it.
MAKING A CALL USING THE LIFTER
Press the Talk Button (20) on the headset. The lifter will raise the telephone handset off the hook. You will then hear a dial tone in your headset and can proceed to make a call as normal.
When you have finished your call press the Talk Button (20) on your headset. The handset lifter then lowers the handset to end the call.
RECEIVING A CALL USING THE LIFTER
When a new call is received the telephone rings as normal, but in addition, a ring alert comprising a repeating sequence of three short beeps will be heard in your headset.
Note: This additional call alert is only active when the Handset Lifter (17) is connected.
To answer the call press the Talk Button (20) on the headset. The lifter will then raise the telephone handset off the hook and you will then be able to talk to the caller.
When you have finished your call press the Talk Button (20) on your headset. The handset lifter then lowers the handset to end the call.
INTELLISTANDTM FUNCTION
When the CS50 Wireless Headset System is used in conjunction with a Handset Lifter (17), you can enable the IntelliStand feature.
The IntelliStand senses when the headset has been removed or replaced in the CS50 Base Unit, automatically activating the lifter to answer or end a call.
The IntelliStand feature is disabled when the IntelliStand switch
(5) is in position I or enabled when the switch is in position II.
EN
8 | 9 |
