IMPORTANT SAFETY INSTRUCTIONS

7

overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

(14)Overloading - Do not overload wall outlets, extension cords, or integral conven- ience receptacles as this can result in a risk of fire or electric shock.

(15)Object and Liquid Entry - Never push objects of any kind into this product to avoid fire or electric shock. Never spill liquid of any kind on the product.

(16)Servicing - Do not attempt to service this product yourself. This product should only be opend by qualified service personnel.

(17)Damages Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions.

a)When the power - supply cord or plug is damaged.

b)If liquid has been spilled, or objects have fallen into the product.

c)If the product has been exposed to rain or water.

d)If the product does not operate normally by following the operating instruc- tions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its nor- mal operation.

e)If the product has been dropped or damaged in any way.

f)When the product exhibits a distinct change in performance - this indicates a need for service.

(18)Replacement parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

(19)Safety Check - Upon completion of any service or repair to this product, ask the service technican to perform safety checks to determine that the product is in proper operating condition.

(20)Heat - The product should be situated away from heat sources such as radia- tors, heat registers, stoves or other products (including amplifiers) that produce heat.

(21)During playback, few bright or dark spots may appear on the TFT LCD, which is a normal phenomenon in active matrix display technology, and not a malfunction.

Page 7
Image 7
plawa-feinwerktechnik GmbH & Co.KG 7x manual Important Safety Instructions