Plinius Audio 9200 manual Specifications, WATTS RMS PER CHANNEL INTO 8 OHMS

SPECIFICATIONS

200-WATTS RMS PER CHANNEL INTO 8 OHMS.

BOTH CHANNELS DRIVEN FROM 20Hz TO 20kHz AT LESS THAN 0.2% TOTAL HARMONIC DISTORTION.

FREQUENCY RESPONSE: 20Hz to 20kHz ±0.2dB. -3dB at 5Hz and -3dB at 70kHz.

DISTORTION: Typically <0.05% THD at rated power. 0.2% THD and IM worst case prior to clipping.

4 OHM POWER: 300 Watts per channel or greater.

CURRENT OUTPUT: 40A short duration peak per channel. Fuse protected.

SLEWING: 50V/∝s.

HUM & NOISE: 90dB below rated output 20Hz to 20kHz unweighted.

INPUT SENSITIVITY: 300mV RMS for rated output at 1kHz. 1.5mV RMS on Phono low gain setting. 0.75mV on Phono high gain setting.

INPUT IMPEDANCE: 47kΩ.

INPUT OVERLOAD: 5V RMS.

PHONO STAGE GAIN (PHONO INPUT TO PRE-OUT):61dB on high gain setting, 54dB on low gain setting.

RATED PRE OUT LEVEL: 1.5V RMS into 47kΩ or higher. Maximum 6V RMS into 10kΩ or higher.

PRE OUT SOURCE IMPEDANCE: Typically 1.5kΩ.

PRE OUT MINIMUM RECOMMENDED LOAD: 47kΩ.

TAPE OUTPUT LEVEL: 190mV at 200Ω. Tape loop muting at 5V RMS input.

HEIGHT: 120mm (4 3/4")

WIDTH: 450mm (17 3/4")

DEPTH: 400mm (15 3/4")

WEIGHT: 14kg (30lbs)

17