Polaris 380 Quick Installation Instructions, Install the Universal Wall Fitting, English

English

Quick Installation Instructions

Four quick steps to install and get maximum performance from the Polaris 380:

•Install the Universal Wall Fitting (UWF) with Quick Disconnect

•Adjust feed hose to fit pool length

•Assemble the cleaner

•Check for proper wheel RPM (revolutions per minute)

Install the Universal Wall Fitting

1 Installs in minutes on pools with a dedicated cleaner return line and a threaded 1-1/2” female pipe fitting.

1.Turn on the filtration pump and flush out the plumbing line.Turn pump off.

2.Remove the UWF from the Quick Disconnect and screw the UWF with the blue restrictor disc into the return opening.

3.Turn the Quick Disconnect clockwise into the UWF and pull away to secure.

Return Line

Restrictor Disc

Universal Wall Fitting

Filter Screen

Quick Disconnect

Pressure Relief Valve

2 Adjust Feed Hose To Fit Pool Length

Measure the deepest part of the pool. Cut leader hose, from end that attaches to feed hose, so length is equal to the greatest depth of the pool.

Attach leader hose to feed hose and connect hose to the pool wall at the return line. Extend hose to farthest point of pool. The hose end must be within 6" – longer or shorter – of the farthest point. See dotted circle.

Hose too long? Separate hose at center swivel. Cut equal amounts of the overage from each 10-foot feed hose section.

Hose too short? Buy an additional feed hose section (part #9-100-3104), one swivel (part #D20) and two hose nuts (part #D15) from an authorized Polaris dealer.

After adjusting hose, position hose floats as shown.

Leader Hose

Length = Max. Depth

Return
Line	dFe Hose Floats
	1.5 to t3' apar	Center	Leader Hose Floats
		Swivel	2-3' apart

www.polarispool.com