System Setup
SPEAKER SETUP
1. DOWNMIX (LT/RT, STEREO and 5.1CH)
Selecting “LT/RT” in the “DOWNMIX” will alter the audio output into a mixed Dolby output.
By selecting “STEREO” in the “DOWNMIX”, the player will output a normal stereo signal.
By selecting “5.1CH” in “DOWNMIX” will alter the setup of center and rear speakers.
2. CENTER, REAR and SUBWOOFER (ON and OFF)
Allows you to select “ON” or “OFF” for the center, rear and subwoofer. Only when DOWNMIX is in “5.1CH” status, the setup of center, rear and subwoofer speakers can be carried out.
3. CENTER DELAY, REAR DELAY
Having activated the center and rear speakers, now you should set “CENTER DELAY” and “REAR DELAY”.
4. TEST TONE
This function is available only as the “DOWNMIX” is in “5.1CH” status and the disc is not loaded.
AUDIO SETUP
1.SPDIF (OFF, SPDIF/RAW & SPDIF/PCM)
This item is used to set the format of digital audio.
“SPDIF/RAW” outputs the original. For example, if a disc being played is Dolby Digital, then the digital audio is also Dolby Digital.
”SPDIF/PCM” means that PCM channel signal is output to speakers that has only two output channels.
2. OP MODE (LINE OUT and RF REMOD)
Select “LINE OUT”, and then it will do linear process to audio signal during audio decoding.
Select “RF REMOD”, and then it will do RF process to audio signal during audio decoding.
3. COMPRESSION
You can adjust linear dynamic compression rate to achieve different compression effects.
4. LPCM OUTPUT (LPCM 48K & LPCM 96K)
There are two kinds of sampling frequency for selection.
- 23 -
