Names and functions of each part (continued)
• Auto adjust can take up to 30 seconds.
•Auto adjust may not operate correctly in some cases, depending on the computer connected and the signal.
•Be sure to expand images to full screen size when displaying low resolution images.
•After auto adjust, the image may be slightly dark in some cases due to automatic adjustment of the signal level.
•Auto adjust can not execute when the initial display is “NO INPUT IS DETECTED” or “SYNC IS OUT OF RANGE” during FREEZE or MAGNIFY.
•Auto Adjust is executed when the following operations are performed.
1.When the type of input source signal is changed.
2.When the Auto Adjust (AUTO) button is pressed.
•The message AUTO IN PROGRESS will be displayed on the screen during automatic adjustment.
•The screen may be disrupted during automatic adjustment but this is not a malfunction.
•RGB1 or RGB2 only can be used as the input signal.
•Auto Adjust can also be executed using the operation buttons of the main unit. Hold down the RESET button and press the input switch (INPUT) button.
Loading the batteries Loading AA batteries into the remote control.
1Remove the battery cover.
Push the knob while lifting up the battery cover.
Battery usage cautions
•Use only the specified batteries with this projector. Also, do not mix new and old batteries. This could cause in battery cracking or leakage, which could result in fire or personal injury.
•When loading the batteries, make sure the plus and minus poles are correctly oriented as indicated in the projector. Incorrect orientation could cause battery cracking or leakage, which could result in personal injury or pollution of the surrounding environment.
2Loading the batteries.
Make sure the plus and minus poles are correctly oriented.
3Close the battery cover.
Remote control usage cautions
•Do not drop the remote control or apply impact.
•Do not wet the remote control or place it on any wet object. Such actions could result in malfunction.
•When not to be used for an extended period, remove the batteries from the remote control.
•Replace the batteries when remote control operation becomes difficult.
•Do not place the remote control close to the cooling fan of the projector.
•Do not disassemble the remote control in case of malfunction. please bring it to the service station.
Warning The laser pointer of the remote control is used as a pointer.
Never look directly into the laser beam outlet or point the laser beam at other people.
