Note: The RTSC speaker is designed to be used as a THX® center channel speaker. It mounts between studs that are 16" OC (on center).
RTSC ENCLOSURE
The enclosure must be used for the RTSC to perform to THX® certified standards.
REMOVING THE CLOTH GRILLE
The RTSC’s cloth grille fits tightly to the speaker Baffle.
If you use the cloth grille, take special care when removing it.
Important Note: Never use any tool, such as a paperclip, to remove the grille, as this could tear the cloth.
Instead, use your hands (after you’ve washed them), grasping the grille frame near two of its mounting cups and pulling the frame firmly away from the baffle.
WIRE RECOMMENDATIONS
Runs | Gauge |
Lengths up to 25' | 18 or 16 |
Lengths greater than 25' | 16 or 14 |
but less than 50' |
|
Lengths greater than 50' | 14 or 12 |
but less than 75' |
|
Lengths greater than 75' | 12 |
Mount Performance Enclosure using included hardware. Run wire from any direction and plug the hole to maintain an airtight seal.
Overall Height
Overall Width | Depth measured |
14" (35.56cm) | from the back of the |
| enclosure to the front |
|
SPECIFICATIONS
Product Weight: 8.75 lbs. (3.97kg)
(not including Performance Enclosure)
P E R F O R M A N C E
POWER HANDLING (WATTS/CHANNEL) | |
IMPEDANCE (NOMINAL) | 4 OHMS |
|
|
FREQUENCY RESPONSE (OVERALL) | |
THX SPEC | |
|
|
EFFICIENCY (2.83V@1M) | 92dB |
|
|
WEIGHT |
|
SPEAKER | 8.75 LBS (3.97KG) |
PERFORMANCE ENCLOSURE | 9.25 LBS (4.25KG) |
|
|
D R I V E R C O M P L E M E N T
MIDBASS | |
| AERATED POLYPROPYLENE |
| DYNAMIC BALANCE™ DRIVERS |
|
|
TWEETER | |
| AIMABLE RING RADIATOR TWEETER |
|
|
Web Address: | C O N N E C T I O N S |
| |
For more information on the | SPEAKER WIRE |
| |
MAXIMUM WIRE SIZE ACCOMMODATED | 12 AWG | ||
www.polkaudio.com/downloads/manuals/ | |||
MINIMUM RECOMMENDED | 18 AWG | ||
|
| ||
INPUT CONNECTORS | |||
| |||
|
| PUSH TERMINALS | |
|
|
|
2
P o l k A u d i o C u s t o m I n s t a l l P r o d u c t : M o d e l N u m b e r