Polk Audio LCI-RTSFX Stud-LockMounting System RTSFX only, SPECIFICATIONS LCi-RTSFX, Web Address

Stud-Lock Mounting System™ (RTSFX only)

Installation: See the instructions included with each Stud- Lock Mounting System™.

Important Note: For new construction: If you are using a pre- construction bracket, always install it first before installing the Stud-Lock Mounting System™ .

If you are installing a pre-construction bracket (PBC) and a Stud- Lock Mounting System (STL105) together, be aware that the speaker’s enclosure can catch on the edge of the pre-construc- tion bracket. Push the bottom of the loudspeaker enclosure up and over The protruding edge of the pre-construction bracket. This will fully seat The loudspeaker in the wall.

SPECIFICATIONS

LCi-RTSFX

Installed Weight: 10.75 lbs. (4.88kg)

(not including Stud-Lock Mounting System™)

P E R F O R M A N C E

POWER HANDLING (WATTS/CHANNEL)	10-250W CONTINUOUS
IMPEDANCE (NOMINAL)	4 OHMS
FREQUENCY RESPONSE (OVERALL)	50HZ–27KHZ
THX SPEC	80HZ-26KHZ
EFFICIENCY (2.83V@1M)	88dB
SPEAKER WEIGHT (INSTALLED)	10.75 LBS (4.88KG)

D R I V E R C O M P L E M E N T

MIDBASS	2-5 1/4" (13.34CM)
	AERATED POLYPROPYLENE
	DYNAMIC BALANCE™ DRIVERS
TWEETER	1-1" (2.54CM)
	RING RADIATOR TWEETER

Important Notes:

If you are using a Pre-Construction Bracket, always install the Pre-Construction Bracket before installing the Stud-Lock Mounting System™. Be sure to clear the Pre- Construction Bracket wire guide when installing the Stud-Lock Mounting System™.

STL105

Center the bracket vertically in the cutout. The lip of the Stud- Lock bracket and the cutout should align.

Drywall shown cut away for clarity.

C O N N E C T I O N S

SPEAKER WIRE
MAXIMUM WIRE SIZE ACCOMMODATED	12 AWG
MINIMUM RECOMMENDED	18 AWG
INPUT CONNECTORS	HEAVY-DUTY SPRING LOADED
	PUSH TERMINALS

Web Address:

For more information on the LCi-RTSFX, log onto

www.polkaudio.com/downloads/manuals/ home/LCi-RTSFX_manual.pdf

4

P o l k A u d i o C u s t o m I n s t a l l P r o d u c t : M o d e l N u m b e r