Polycom 1725-36032-001, 8000 Change Password

Configuring the SpectraLink 8000 SVP Server

RTP traffic is the audio traffic to the PBX. It requires voice quality.

PBX traffic is not audio to the PBX.

Inter-SVP2 traffic is the information-passing protocol that SVP

Servers use to communicate with each other.

The final DSCP tag of traffic for packets in each of the above Traffic

Classes is governed by the logic below when SVP is used in an SRP

environment:

• If in-call and WT (In call) value is not Default then the configured

value is used. Valid range is 0-63.

• If not in-call and WT (Standby) value is not Default then the

configured value is used. Valid range is 0-63.

• Default means “shall not change value of DSCP tag”, in other

words the received DSCP value (from the Gateway) is passed

transparently.

If this option is selected, you will be prompted to reset the SVP Server

upon exiting this screen.

The SVP Server should be reset at the end of any maintenance

procedure that requires a reset either via Maintenance Lock or

manually via Reset System.

Note that resetting the SVP Server will terminate any calls in

progress.

Change Password

If desired, the password to access the SVP Server may be changed.

A password must meet the following requirements:

• It must be more than four characters, but cannot exceed 16

characters.

• The first character must be a letter.

• Numbers or letters are allowed.

• No dashes, spaces, or punctuation marks, etc. are allowed.

PN: 1725-36032-001_F.doc 2