Polycom 1725-36060-001 manual Radio profile commands

Configuration Guide

# defines a passphrase

set service-profile Voice auth-psk enable

#enables pre-shared key authentication set service-profile Voice auth-dot1x disable

#disables 802.1x authentication

set service-profile Voice attr vlan-name default

# maps the handsets to the vlan named default

Radio profile commands

Assume you are creating radio profile “voice” for all radios that will be providing voice services. The following commands are needed to setup the radio profile for the access points:

set radio-profile voice service-profile vowlan-wpa2

#maps the service profile to the radio profile set radio-profile voice dtim-interval 3

set radio-profile voice active-scan disable

#prevents the AP from going off-channel to scan

set radio-profile voice auto-tune channel-config disable

#disables dynamic channel tuning for radios in this profile.

set radio-profile voice qos-mode svp

# qos mode SVP must be set for SVP to be supported

Network topology and MP access point hardware configuration

The network topology and access point hardware configuration can be configured using the Mobility System software. Please refer to the Trapeze Networks Mobility System Software Configuration Quick Start Guide or the Trapeze Mobility Exchange Installation and Basic Configuration Guide for more information. Some useful commands are:

To create VLAN “v1” and add port 3 as a member of “v1:”

set vlan 2 name v1 port 3

#2 is the VLAN ID (must be unique for every VLAN on the switch)

To create a configuration for a model MP-422 access point that is directly attached to port 1 of an MX switch:

set port type ap 1 model mp-422 poe enable

8 PN: 1725-36060-001_D.doc