Trapeze Networks: Mobility System for MP 422 Access Points
Radio configuration
During VIEW Certification, the MP access points were tested directly connected to a port on the MX (e.g. port 1). The following commands will configure a specific access point’s radio to support the voice service:
set ap 1 radio 1 mode disable
#if the radio is currently enabled. Radio 1 is the 802.11b/g radio
set ap 1 radio 1
# maps radio to the
MP access points that are not directly connected to a port on the MX, which Trapeze calls a distributed access point (DAP), were not tested. If they are desired, the radio is configured with this command:
set dap 1 radio 1 mode disable
#if the radio is currently enabled. Radio 1 is the 802.11b/g radio
set dap 1 radio 1
# maps radio to the
SVP configuration
The following commands are needed to enable SpectraLink Voice Priority via access control list (ACL) “SVP.”
This rule places all IP protocol 119 (SVP) traffic on class of service (CoS) queue 7 (SVP support):
set security acl ip SVP permit cos 7 119 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255
(Optional) This rule permits all other data traffic. Do not use if the VLAN “v1” is dedicated to voice services. Note: There is an implicit “deny all” rule at the end of the ACL.
set security acl ip SVP permit 0.0.0.0 255.255.255.255 set security acl map SVP vlan v1 out
#maps the ACL to VLAN v1 for outbound traffic commit security acl SVP
#activates the ACL
Be sure to disable IGMP snooping on VLAN “v1” by using the command:
set igmp disable vlan v1
PN: | 9 |
