Transferring audio between VoiceStation™ 500 and mobile phone (for privacy)
1.Dial a telephone call according to the directions in “Making and ending a Bluetooth mobile phone call”.
2.To transfer the audio from the VoiceStation™ 500 to the mobile phone, press the * button.
3.To transfer the audio from
the mobile phone back to the VoiceStation™ 500, press the * button again.
Changing between mobile phone calls us- ing VoiceStation™ 500
•Use the Flash function on your mobile phone to change between the two phone calls.
Muting a call on VoiceStation™ 500
•Press the Mute button on the
VoiceStation™ 500 to mute/unmute a call as described in the “POTS Mode” section of this User Guide.
Changing Volume
•Press the Volume Up/Down buttons on the VoiceStation™ 500 to adjust the volume to the desired level as described in the “POTS Mode” sec- tion of this User Guide.
Recording a Bluetooth audio call
•Please refer to the ‘Record a Con- versation’ as described in the “POTS Mode” section of this User Guide.
Making a POTS call while in Bluetooth mode
1.If you are in a call using your Blue- tooth device, place the call on hold by pressing the Mode button on the
VoiceStation™ 500 and ensure that no LED is lit. If you do not press the Mode button to exit Bluetooth mode, the last number dialed will automatically be dialed again when
you press the On/Off button.
2.Press the On/Off button on the VoiceStation™ 500 to get the POTS dial tone.
3.Dial the call using the keypad of the VoiceStation™ 500.
4.To end the call, press the On/Off button on the VoiceStation™ 500.
5.To resume the Bluetooth call, press the Mode button on the
VoiceStation™ 500.
Changing between calls in different modes (POTS to/from Bluetooth)
1.To make a POTS call while in
Bluetooth mode, press the Mode button, press the On/Off button, then dial the phone number. When complete, press the On/Off button.
Press the Mode button to return to the call in Bluetooth mode.
2.To answer a POTS call while in
Bluetooth mode, press the On/Off button.
Disconnecting Bluetooth link using VoiceStation™ 500
•Press and hold the Mode button for 3 seconds while in Bluetooth mode.
You should see the steady blue LED turns to slow blinking with an audible beep.
Using VoiceStation™ 500 with Bluetooth-Enabled Computer(s):
Configuring the VoiceStation™ 500 for Bluetooth Mode
1.Press the Mode button to enter Bluetooth mode. The blue Mode LED should be on (either slow blinking or steady).
VoiceStation™ 500 - 10
