Polycom A200, A2400, A6000, A800 Connecting APs

Aruba Mobility Controllers: A200, A800, A2400, A6000

PN: 1725-36080-001_J.doc 11

Connecting APs

The APs need to be provisioned. The Aruba APs can be provisioned

manually or be configured for automatic provisioning. For manual

provisioning, use the Web-based AP provisioning Web page. Refer to

the AP Provisioning User Guide for instructions on provisioning the

AP.

The APs can communicate with the controller over a L2 or L3

network. The only requirement is that each AP be assigned an IP

address and default gateway using DHCP.

Contents

Main Trademark Information Patent Information Copyright Notice Notice Contact Information Introduction Certified Product Summary Customer Service Network Topology Known Limitations Deployment Description Interface setting Default route Physical interface Connecting the APs Connecting to the Mobility Controller Command, comment, and screen text key Via console Via the CLI Via the Web interface Initial Setup Page Assigning an IP to the Mobility Controller Connecting APs Provisioning APs SSID Configuration CLI command configuration Web-based configuration Access Point Configuration Radio setting 802.11b or 802.11g Preamble settings Channel and Tx power Recommended AP configuration settings Page CLI command configuration Web-based configuration Page Page Dynamic RF Management ARM Aware Scanning Security Policies and QoS Create an alias for the SVP Server Page Assign policies to the role Page Authentication Quality of Service (QoS) Subnet Roaming CLI Commands to Set Up Subnet Roaming Commands for the master switch (the Aruba 800) Commands for the local switch (the Aruba 6000) The APs IP address must be on the same subnet as the switch. CLI Commands to Verify Setup for Subnet Routing From the Aruba 800 From the Aruba 6000 Checking the Configuration