Configuration Guide
PN: 1725-36080-001_J.doc
12
SSID Configuration CLI command configuration
APs can be configured using the CLI or the Web interface. Each AP is
identified by a unique location code. The APs can either be configured
per location with unique settings using the AP’s unique location code
or globally using the wildcard location. “0” is used as the wildcard.
Example: ap location 0.0.0 will configure all Aruba APs on the
WLAN system. Both the Aruba APs and the Spectralink handsets
support the 802.11a and the 802.11b/g radios. To apply the SSID to
both bands configure the SSID as follows:
configure terminal
ap location x.y.z
virtual-ap aruba vlan-id 26 opmode wpa2-aes-psk
wpa-passphrase thisisthekey dtim-period 3
If the voice network needs to exist only in the 802.11a band ,
configure the virtual AP under the 802.11a settings on the controller.
configure terminal
ap location x.y.z
phy-type a virtual-ap aruba vlan-id 26 opmode wpa2-aes-
psk
wpa-passphrase thisisthekey dtim-period 3
If the voice network needs to exist only in the 802.11g band, configure
the virtual AP under the 802.11g settings on the controller.
configure terminal
ap location x.y.z
phy-type g virtual-ap aruba vlan-id 26 opmode wpa2-aes-
psk
wpa-passphrase thisisthekey dtim-period 3
To save changes, enter:
write mem