18
For support when cutting long pieces, construct a work
support extension. Fig. 39 illustrates the miter saw mounted
on two standard 2 x 4’s (A). Fasten the four mounting legs
(two of which are shown at (B) Fig. 39 to the 2 x 4’s, using
four screws (not supplied) through the four holes in the
mounting legs. The length of the 2 x 4’s (A) can vary,
depending on the workpiece.
NOTE: Ensure that the top of the support 2 x 4’s (C) are
level with the miter saw table. This is critical because the
distance from the top of the 2 x 4’s (A) to the miter saw table
varies from saw to saw. In most cases, standard 2 x 4’s (C)
can used. If these are too high, cut them to fit. If the 2 x 4’s
are too low, use 2 x 6’s. If these are high, cut them to the
correct height.

WORK SUPPORT EXTENSIONS

CUTTING ALUMINUM
Aluminum extrusions such as used for making aluminum
screens and storm windows can easily be cut with
your compound miter saw. When cutting aluminum
extrusions, or other sections that can be cut with a saw
blade and are within the capacity of the machine,
position the material so the blade is cutting through the
smallest cross-section (Fig. 35). The wrong way to cut
aluminum angles is illustrated in Fig. 36. Be sure to apply
a stick wax to the blade before cutting aluminum stock.
This stick wax is available at most industrial mill supply
houses. The wax provides proper lubrication and keeps
chips fromadhering to the blade.
NEVER APPLY LUBRICANTTO THE
BLADE WHILE THE MACHINE IS
RUNNING.
FENCE BLADE

WRONG

FENCE
BLADE

RIGHT

CUTTING BOWED MATERIAL
When cutting flat pieces, first check to see if the material
is bowed. If it is, make sure the material is positioned on
the table as shown in Fig. 37.
If the material is positioned the wrong way, as shown in
Fig. 38, the workpiece will pinch the blade near the
completion of the cut.
RIGHT WRONG
Fig. 35
Fig. 36
Fig. 37 Fig. 38
A
C
B
Fig. 39