Diagnostics and Troubleshooting
Printer Error Messages
If the error message continues to occur after implementing the possible solutions from the table below, call your service person.
Error | Error Message | Possible Cause | Possible Solution | |
Code | ||||
|
|
| ||
|
|
|
| |
1 | not initialized | Attempting to perform a function | Reinitialize the printer. | |
|
| before the printer has initialized. |
| |
|
|
|
| |
2 | initializing err | Attempting to perform a function | Wait for initialization to complete and | |
|
| during the initialization process. | try the function again. | |
|
|
|
| |
3 | busy | Attempting to perform a function | Wait for the previous function to | |
|
| while the printer is busy performing | complete and try the function again. | |
|
| another function. |
| |
|
|
|
| |
4 | out of paper | Paper cassette is empty and the | Load a full paper cassette into the | |
|
| paper path sensors do not detect | printer. | |
|
| paper. |
| |
|
|
|
| |
5 | end of roll at supply | Printer has run out of paper and the | Remove the tail end of the paper at | |
|
| tail end of the paper has been | the supply door and load a full supply | |
|
| rewound to the paper supply area. | cassette into the printer. | |
|
|
|
| |
6 | paper already loaded | “Load Paper” was selected when | Solution not required. | |
|
| paper was already loaded. |
| |
|
|
|
| |
7 | supply door open, | The paper supply door was left | Close the paper supply door. | |
| please close | open. |
| |
|
|
|
| |
8 | front door open, please | The front door was left open. | Close the front door. | |
| close |
|
| |
|
|
|
| |
9 | back door open, please | The back door was left open. | Close the back door. | |
| close |
|
| |
|
|
|
| |
10 | takeup door open, | The takeup door was left open. | Close the takeup door. | |
| please close |
|
| |
|
|
|
| |
12 | motor busy | A low level motor move command | Wait for the motor move to complete | |
|
| was issued while the timer motor | or stop the motor and reissue the | |
|
| was in use. | command. | |
|
|
|
| |
13 | motor setup invalid | A low level motor move command | Wait for the motor move to complete | |
|
| was issued while the timer motor | or stop the motor and reissue the | |
|
| was in use. | command. | |
|
|
|
| |
14 | bad printer state | The printer cannot execute the | Reinitialize the printer. | |
|
| requested command. |
| |
|
|
|
| |
15 | timers busy | A low level motor move command | Wait for the motor move to complete | |
|
| was issued while the timer motor | or stop the motor and reissue the | |
|
| was in use. | command. | |
|
|
|
| |
16 | timer spurious interrupt | A spurious (false) timer interrupt | No solution required. | |
| code | has occurred. |
| |
|
|
|
| |
17 | command not | The function requested is not | No solution required. | |
| implemented | supported in this software release. |
| |
|
|
|
|
September 2000 |