Kodak 20R manual Operating Procedures, shelf Emulsion image side of paper or paper saver

Operating Procedures

Installing the Loaded Paper Supply Into the Printer

1.Open the paper supply door.

2.Empty the punch chad tray. See “Removing the Punch Chad” on page 4-2.

3.Align the slot on the bottom of the supply cassette with the plate on the bottom of the shelf and slide the supply cassette into place on the shelf.

shelf

Emulsion (image) side of paper (or paper saver)

plate

cassette clamp

slot

4.Check that the gear on the supply cassette aligns and meshes with the gear on the printer.

5.Lock the clamp to secure the paper cassette into place.

6.If you are not using the digital printer paper saver, check that the cut on the lead edge of the paper is straight.

NOTE: Use scissors to cut the paper. Knives and razor blades will shred the paper.

7.Adjust the right punch to the correct paper width (10, 11, 12 or 20 inch and A4). See “Adjusting the Paper Hole Punchers” on page 3-22.

8.Press Start on the OCP.

9.Enter the number of feet on the roll of paper when prompted and if necessary, enter the roll ID. See “Using the Automatic Roll ID” on page 3-29.

3-12 September 2000