Additional Calibration Information
IMPORTANT: Whenever you click OK, the software assumes ALL changes to the Edit Configuration are complete and the Edit Configuration screen closes. Similarly, you can click Cancel at any time while the Edit Configuration screen is open; any changes you made to any of the tabbed information are canceled and the Edit Configuration screen closes.
Note that for Macintosh users only, you can click Default at any time to reset the attributes to their factory defaults and then click OK to save the defaults.
Editing Information on the Procedure Tab
The Procedure tab contains general configuration attributes as shown and described below. The values displayed in the example are the default settings.
Procedure | Description | |
Attribute | ||
| ||
|
| |
|
| |
Graphing | Instructs the application when to display the graphs of the data | |
|
| |
Tolerance Level | Indicates whether the level of tolerance is Normal, Loose, or Strict | |
|
| |
Out of Tolerance | Provides the flexibility to interact at each step or to use a fully | |
| automated calibration | |
|
| |
Maximum Cycles | Indicates the maximum number of iterations the calibration | |
| procedure will perform if “Out of Tolerance” is set to “Automatically | |
| iterate up to maximum cycles.”. | |
|
| |
Processor In Control | Indicates whether the Processor In Control dialog box is to be | |
| displayed at the beginning of the calibration process | |
|
|
September 2000 |
