Kodak 20R Operating Procedures, outline of paper outline of image, 0.25 in, cut punches white

Operating Procedures

outline of paper outline of image

Gutter Punch—controlled by a command sent from the host computer. See “Changing the Gutter Width” on page 3-35.This punch is on the same side as the cut punch and is 0.25 to 1.0 in. inside of the image (depending on the value of the gutter width).

Cut and Order Punches on Same Side of the Paper

	0.25 in.
	cut punches white
	order punch
0.25 in.	front of the printer
white

Cut and Order Punches on Opposite Sides of the Paper

cut punches

order punch

Gutter Punches With Cut and Order Punches on Opposite Sides of the Paper gutter width 0.25 in.

cut punches

order punch

order punch gutter punches

NOTE: All three types of paper punches are made at the trail edges of the print.

Determining the Location of the Cut and Order Punches

1.Select “Setup” from the main menu on the OCP.

2.Select “Printer”.

3.Select “Cut Punches” or “Order Punches”.

4.Select “<>Punch Position”.

5.Select “front” or “back”.

6.Select “<> Punch Enabled”.

3-28 September 2000