Kodak 20R manual Diagnostics and Troubleshooting, on device devicename, device:_devicename_

Diagnostics and Troubleshooting

Error	Error Code /Status	Possible Cause/Subsystem	Possible Solution
Code	Message
111	There is insufficient memory	The application does not have	Close the other applications and
	for the requested operation	enough memory to complete the	unnecessary windows.
	on device:_devicename_.	operation.
112	A communications time-out	The connection between the	Check that all of the cables are
	occurred during operation on	printer and host computer was	properly connected.
	device:_devicename_.	lost.
113	A device driver for the	The application could not find the	Make sure that the Calibration
	following device could not be	necessary device software to	Application and ASPI SCSI device
	found:_devicename_.	communicate with the printer.	driver are installed correctly.
114	An error occurred during	• The cable between the printer	• Check that all of the cables are
	communications to the	and the host computer is worn.	properly connected.
	following device:	• One or more of the	• Check the cables and
	_devicename_.	connections between the	connections between the printer
		printer and the host computer	and the host computer for wear
		has malfunctioned.	and if necessary, replace them.
115	An operation error occurred	• The cable between the printer	• Check that all of the cables are
	during communications to	and the host computer is worn.	properly connected.
	the following device:_	• One or more of the	• Check the cables and
	devicename_.	connections between the	connections between the printer
		printer and the host computer	and the host computer for wear
		has malfunctioned.	and if necessary, replace them.
116	A software warning has been	A software error has occurred on	Resolve printer error condition.
	issued by the following	the printer.
	device: _devicename_ Error
	Message: _errmsg_
117	A software error has been	An error has occurred on the	Resolve printer error condition.
	detected by the following	printer.
	device: _devicename_ Error
	Message: _errmsg_
118	A SCSI ID for the following	SCSI driver not found.	Reinstall SCSI driver on host
	device was not found:		computer.
	_devicename_.
119	The wrong SCSI ID was	SCSI ID is incorrect.	Set Target SCSI ID to printer SCSI
	specified for the following		ID.
	device: _devicename_.
120	This device has been setup	Device chosen has not been	Verify device chosen matches the
	for the wrong model of	found.	printer model.
	printer: _devicename_.
121	Unable to read STATUS from	Unable to see the printer.	Check SCSI cable connections.
	device: _devicename_.
122	The selected LUT contains	Trying to send a 12-bit LUT to a	Select a 10-bit LUT file.
	data that exceeds the limits	10-bit printer.
	of this printer.
201	An error occurred while	The system is trying to allocate	Close any unnecessary
	trying to allocate memory.	memory, however, no memory is	applications.
		available.

5-16 September 2000