JVC TDR6 Error Messages Explanation Action Required, Informational Remote Commands Response

Error Messages If the TDR6 is not able to execute a command, an error message will be returned, indicating the command was not completed. TDR6 error messages, along with the action required to resolve the error, are explained in the following table.

Error Messages

Message	Explanation	Action Required
Error	The TDR6 was unable to execute the	Repeat the requested command. If the command
	requested command. This is a	still results in an error message, check the
	summary error, which may indicate a	configuration of the unit and repeat the command.
	hardware failure or configuration	If an error results, reset the unit and attempt the
	abnormality.	command again. If you are unable to execute the
		command, contact Customer Service.
Format Error	The command syntax was entered	Re-enter the command using the proper syntax
	incorrectly.	and format.
Parameter Error	The TDR6 does not recognize the	Re-enter the command using the correct
	parameter. A numerical parameter may	parameter.
	be out of range, or an ASCII character
	string may not match any of the
	available parameters for the command.
Not Supported	The requested command does not	Review the lists of commands to ensure that you
	match any valid TDR6 command.	entered a valid command.

In addition to the actions listed in the error messages table, you can also enter the following types of commands to receive additional information when errors are encountered or additional information is needed.

Informational Remote Commands	Response
<mnemonic>	Displays system information associated
For example: ADA	with that command.
<mnemonic> <instruction> ?	Lists information available for that
For example: MC RS232 BAUD ?	particular command, including all valid
	parameters

Command The standard TDR6 remote commands are listed in the following table, which Descriptions provides the following information:

NOTE

■Remote command mnemonic

■Parameter values or command response values

■Factory DVB-compliant default value

■Description of the command, including parameter definitions and the front panel command equivalent

Commands used to set a parameter may also be used to query the current command. Use the command mnemonic without a parameter and the TDR6 will return the current parameter setting.

The specific commands available depend on the option modules installed in your TDR6.

36 01-0870-401B 01/03 Using a Remote Unit