Execute commands consists of a command mnemonic, which is followed by a space, the command instruction, a space, and the parameter.
Command = |
| mnemonic | instruction parameter | |
} } | } | |||
| { | MC RS232 | BAUD | 1200 |
■Query commands direct the TDR6 to display the current setting of a specific parameter or to display current status information.
Query commands consists of a command mnemonic, which is followed by a space, and the command instruction. Query commands are issued by typing the command, without a parameter, and pressing Enter. The TDR6 responds to the query by displaying information on the remote display.
Command =
| mnemonic |
} | |
{ | MC RS232 |
instruction
}
BAUD
The TDR6 uses the following command mnemonics to group various commands:
■AD – audio decoder commands
The TDR6 can be configured with up to six separate audio channels based on the installed option cards. The ports are identified based on the following:
❒
❒
❒
If only a
If only a
If both option modules are installed, audio ports A, B, C, and D correspond to the digital audio ports located on the
■DC – decoder services management commands allow you to configure various decompressor/decoder control operations.
■DMD – demodulator commands allow you to configure each of the four LNB input ports and to display receive signal status information. For DMD commands, a period must be entered to separate the mnemonic from the channel designator.
❒demodulator A (DMD.A) — used to configure LNB A
❒demodulator B (DMD.B) — used to configure LNB B
❒demodulator C (DMD.C) — used to configure LNB C
❒demodulator D (DMD.D) — used to configure LNB D
■
■
Fault commands enable you to query faults and clear the fault history.
HD –
Using a Remote Unit |
| 33 |
