Leaving a Parameter If you have not pressed the Enter button, you can leave a parameter without modifying it by pressing either the:
■Previous button which returns you to the previous menu level
■Next button which advances you to the next parameter in the list
In either situation, the TDR6 will ignore any values entered and return the parameter to its original setting.
After Pressing the Enter Button If you accidentally issue an incorrect parameter value to the TDR6, you can correct the error by:
1.Selecting the parameter again using the Selection buttons. The parameter will begin to flash.
2.Change the parameter option to the correct value.
3.Issue the parameter again by pressing the Enter button
Example
The following example describes how to move through menus and select options. In this example, the video mode will be set to NTSC. This example applies to the video card located in slot 2, and is for standard definition video.
1. From the DTV Receiver/Decoder main menu, select Details.
DTV Receiver/Decoder | Faults → | |
Config | Details | |
2. From the Low Level Setup menu, select Video.
Low Level Setup |
| Video → |
Input | Service |
3. From the Video Decoder menu, select Slot 2.
Video Decoder Menu
Slot 2
4. From the Slot 2 Video menu, select standard definition.
Slot 2 Video Menu
Std_Vid
5.The Standard Definition Video Decoder menu displays, showing the first video parameter and it’s current setting. Press Next to scroll to the next parameter.
Std Video Decoder | 33 → |
PID = |
20 |
| Front Panel |
