Porter-Cable 3802 instruction manual Assembly Moving Cuttinghead to the UP Position

UNPACKING

1.Carefully remove the machine from the carton. Retain all packing materials until you have inspected and satisfactorily operated the machine.

WARNING: Do not connect the machine to the power source until you have read and understood this entire instruction manual.

2.Place the machine on a firm, level surface with extra room for handling and proper support of the workpiece.

3.Familiarize yourself with all features and controls as explained in this manual.

4.The machine is shipped with the cuttinghead locked in the down position and the table rotated to 45 degrees left, Fig. 2. To release the head and move it to the operating position, see “MOVING CUTTINGHEAD TO THE UP POSITION” and “MOVING THE TABLE TO THE 90 DEGREE CUT-OFF POSITION” in this section.

5.Unassembled items are shown in Fig. 3 for identification and use in assembling the saw.

1Extension table

2Fence slide

3Fence slide support

4Dust bag

5Arbor and fence wrench

6¼" wrench

7Open end wrench

8Lock handle for slide fence

9¼" flat washer

10¼" lock washer

11¼ - 18 x 1 1/4" long hex head screw (2)

12¼ - 18 x 3/4" long hex head screws (2)

Fig. 2

2			3	4
		1
	7	8
	6			5
		11	10	12
			9
			Fig. 3

B

A

Fig. 4

ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE OWNER’S MANUAL.

MOVING CUTTINGHEAD TO THE UP POSITION

1.Pull out cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B) to the up position.

2.Fig. 5, illustrates the lockpin (A) pulled out and the cuttinghead (B) in the up position.

B

A

Fig. 5

5