Porter-Cable 6603 Functional Description, Assembly, Operation, Foreword, How To Hold The Shear

FUNCTIONAL DESCRIPTION

FOREWORD

The Porter-Cable Model 6603 Shear is designed for cutting cold-rolled steel sheets up to 18 Ga. and stainless steel sheets up to 20 Ga. You can make both straight and curved cuts with a minimum radius of 7". The Shear removes a ¼" wide continuous curl of waste material without bending or burring the finished workpiece.

The Porter-Cable Model 6605 Cement Siding Shear is designed for cutting cement siding. You can make both straight and curved cuts with a minimum radius of 7". The Shear removes a ¼" wide piece of waste material.

ASSEMBLY

NOTE: This tool is shipped completely assembled. No assembly time or tools are required.

OPERATION

HOW TO HOLD THE SHEAR

The gear housing, intermediate plate, and cutting head may become live if the tool cuts into wiring. To prevent accidental shock, hold the tool as shown in Fig. 1.

Fig. 1

TO START AND STOP THE SHEAR

1.Make sure that the power circuit voltage is the same as that shown on the specification plate of the drill, that the switch is in the “OFF” position, and that your hands, body, and clothing are clear of cutting head before connecting the tool to the power circuit.

2.Squeeze the TRIGGER SWITCH (A) Fig. 2 to start the motor. Release the trigger to stop the motor.

3.A lock button (B) Fig. 2 is provided to keep motor running without holding the trigger switch “ON”.

B

A

Fig. 2

9