TO INSTALL & REMOVE THE BIT
DISCONNECT THE TOOL FROM THE POWER SOURCE!
1.Insert the long portion of the hex wrench
(A)Fig. 13 through the spindle lock hole
(B)Fig. 13, so that the wrench protrudes from both sides of the base housing. Rotate the spindle by hand to align the hole in the spindle with the holes in the housing.
2.Clean and insert the bit shank into the collet. Tighten the collet nut securely with the collet wrench.
B
A
Fig. 13
To prevent damage to the drive belt, never tighten or loosen the collet nut with the spindle lock engaged.
3.To remove the bit, reverse the procedure. If the bit will not remove easily, lightly tap the bit shank with a wrench.
To prevent damage to the collet, never tighten the collet without a bit inserted.
ADJUSTING THE DEPTH OF CUT
DISCONNECT THE TOOL FROM THE POWER SOURCE!
1.Loosen the bit in the collet (See "TO INSTALL & REMOVE THE BIT").
2.Place the hex wrench (A) Fig. 14 in the
3.Hold the spindle (C) Fig. 14 with your fingers. Apply light upward pressure on the bit to maintain contact between the bit shank and the adjusting screw. Turn the hex wrench
4.To turn the
A.Remove three
B.Turn
A
B
Fig. 14
Fig. 15
C 
3/16"
15
