Porter-Cable 7320, 7310, 7312 Model 7319 Tilt Base Trimmer Assembly, Using Straight Edge Guide

USING STRAIGHT EDGE GUIDE

You can use the straight edge guide (D) Fig. 5 with either bit for trimming straight edges.

Attach it to the guide base and adjust similar to the other guides.

MODEL 7319 TILT BASE TRIMMER ASSEMBLY

Model 7319 Tilt Base Trimmer is completely attached at the factory. You can remove the base from the Model 7301 motor with a base locking screw (A) Fig. 8.

NOTE: A flat washer (B) Fig. 8 is on the locking screw.

Model 7319 Tilt Base is designed for use with 43216PC flush trim bit for trimming into corners. You may also use it with other “self pilot” trim bits for conventional trimming at 90° setting.

A B

Fig. 8

ADJUSTING THE DEPTH OF CUT

DISCONNECT THE TOOL FROM THE POWER SOURCE!

Loosen the base locking screw and move the motor unit up or down to decrease or increase the depth-of-cut.

You may have to slightly withdraw some bits in the collet to obtain a maximum depth of cut.

When you withdraw a bit, be certain that at least 1/2" of the bit shank is engaged in the collet. Do not use bits that result in having less than 1/2" of the bit shank engaged in the collet. To do so may cause

poor gripping of the collet, resulting in a loose bit. If the bit comes out of the collet, it could cause damage to the workpiece and/or personal injury.

ADJUSTING THE TILT

1.Loosen two tilt locking screws (C) Fig. 9 (one on each side of base) using the provided wrench.

2.Match the base-aligning index mark

(D) Fig. 9 with the desired angle and tighten securely.

3.Make a trial cut on scrap material to check the alignment.

D

C

Fig. 9

13