OPERATION
TO START AND STOP THE TOOL
Make sure that the switch is “OFF” and power circuit voltage is the same as that
shown on the specification plate.
1.Connect the tool to the power circuit.
2.Grip the tool firmly to resist starting torque.
3.Slide the switch button (A) Fig. 11
forward to turn the tool “ON”. When |
|
released, the switch button will | A |
return to the "OFF" position. |
4. To lock the switch in the “ON” position, move the switch to the “ON” position and depress the front end of the switch button (A) Fig. 11. To
release the switch lock, depress the rear end of the switch button.
Allow the tool spindle to stop rotating before putting the tool down.
USING A DISC GRINDER
Be certain that the wheel guard and auxiliary handle are installed.
Firmly grip the auxiliary handle and motor housing (Fig. 12). Lift up the rear of the motor housing so that only the front section of the grinding wheel contacts the work. Use light pressure. Always lift the grinder off the work before starting or stopping the motor. The arrow on the
front gear housing indicates the directionFig. 12 in which the grinding wheel rotates.
TROUBLESHOOTING
For assistance with your tool, visit our website at
12
