90546223 PC1800FL PC180FL 1/6/09 10:22 AM Page 4
•Don’t touch lens surface when bulb is lit or immediately after use.
•Handle light with care around any flammable surface.
•Do not expose light or charger to wet or damp areas. Do not expose light or charger to rain or snow.
•Do not wash light or charger with water or allow water to get inside light or charger.
•While light is in use, do not cover with cloth or other flammable materials due to increased risk of fire.
•Do not operate without lens cover assembly attached.
•For household use only.
WARNING: Burn hazard. Do not operate flashlight or charger near flammable liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes causing personal injury.
WARNING: Shock Hazard. Always remove battery before replacing the lamp. Replace bulb with same type rated KPR 18V 0.3A. Such preventative safety measures reduce the risk of personal injury.
WARNING: The lens gets very hot during use. To reduce the risk of burns, do not touch hot lens. To reduce the risk of fire, keep away from combustible materials while in operation.
CAUTION: When not in use, place tool on its side on a stable surface where it will not cause a tripping or falling hazard. Some tools with large battery packs will stand upright on the battery pack but may be easily knocked over.
SAVE THESE INSTRUCTIONS
SAFETY GUIDELINES - DEFINITIONS
It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used to help you recognize this information.
DANGER: Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates a potentially
hazardous situation which, if not avoided, may result in property damage.
SYMBOLS
The label on your tool may include the following symbols. The symbols and their
definitions are as follows: |
|
| ||
V | volts | A | amperes | |
Hz | hertz | W | watts | |
min | minutes | no | alternating current | |
|
| direct current | no load speed | |
|
| |||
................Class II Construction
(double insulated)
..............safety alert symbol
4
