HOW TO SIPHON CHEMICALS AND CLEANING SOLVENTS
Siphoning chemicals or cleaning solvents is a low pressure operation. NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.
To siphon chemicals:
1.Press
chemical | Barbed Fitting |
| |
hose onto |
|
barbed fitting |
|
located near |
|
high pressure |
|
hose |
|
connection |
|
of pump as |
|
shown. |
|
2.Place other end of chemical hose with filter on it into container holding chemical/cleaning solution. NOTE: The chemical/ water ratio is 7:1, for every 7 gallons of water pumped one gallon of chemical/cleaning solution will be used.
3.Install low pressure (black) nozzle into quick connect fitting of wand, see How To Use Wand paragraph in this section.
4.After use of chemical, siphon clean water through chemical hose to rinse it and pump clean. Chemicals which remain in pump can damage it. Damage to pump due to chemicals will not be covered under warranty.
NOTE: Chemicals and soap will not siphon when wand is in the high pressure setting.
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
Risk of fluid injection and laceration. When using the high- pressure setting, DO NOT allow the
Serious injury will occur.
Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE
CUT! See a physician immediately!
Risk of fluid injection and laceration. Always relieve system pres- sure before changing accessories. Place on/off switch in off
position, turn off water supply, and pull gun trigger until water stops flowing.
Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.
DO NOT use hot water, use cold water only.
Never turn water supply off while pressure washer motor is running or damage to pump will result.
DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.
For outdoor use only. Store indoors.
This Product is intended for intermittent use only. Operate pressure washer one hour or less in a 2 hour period.
If you do not understand these precautions please call
A17914 | 12- ENG |
