Porter-Cable D26126-024-0 instruction manual How to Stop, Before First Start-up

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve: When the air compressor is
operating, the check valve is "open”, allowing	Check Valve
compressed air to enter the air tank. When the
air compressor reaches "cut-out” pressure, the
check valve "closes”, allowing air pressure to
remain inside the air tank.

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off lever to "OFF".

Before First Start-up

Break-in Procedure

Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Auto/Off lever is in the "OFF" position.

NOTE: Pull coupler back until it clicks to
prevent air from escaping through the	Quick
quick connect.	Connect
2. Plug the power cord into the correct
branch circuit receptacle. (Refer to
Voltage and Circuit Protection	On/Auto/
paragraph in the Installation section	Off Lever
of this manual.)
3. Open the drain valve fully	Regulator
(counterclockwise) to permit air to
escape and prevent air pressure
build up in the air tank during the break-in period.

4.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.

5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

6.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

D26126 12 - ENG