Porter-Cable H1000 Grounding The Generator, Obtaining Electricity From The Generator, Cord

GROUNDING THE GENERATOR

An extension cord that is hot to the touch is over-

A grounding lug is supplied with the generator for use when required by local electrical ordinances. Refer to article 250 of the National Electrical Code to clarify any needed grounding information. Your local electric company or a certified electrician should be able to help you with this information.

Grounding Lug

loaded. Repair or replace damaged extension cords immediately.

Double Throw Transfer Switch

Potential hazards exist when a portable electric

generator is connected to the main electrical supply coming into the house. It is at that point that the electrical generator could feed back into the utility company's system causing possible

NOTE: Your engine is already grounded to the frame by a grounding strap.

OBTAINING ELECTRICITY FROM THE GENERATOR

There are basically 2 ways to obtain electricity from a gener- ator:

1.Use of extension cords directly from the generator to the appliance, lights, tools, etc.

2.Use of a double-throw transfer switch installed directly to the main electrical supply outside of house.

Extension Cords

When using an appliance or tool at a considerable distance from the generator, a 3-wire extension cord that has a 3- blade grounding plug and a 3-slot receptacle that accepts the tool's plug MUST be used in order to reduce the risk of electrical shock. A cord of adequate size must be used. Using the following chart to determine the minimum wire size required.

Extension Cord Wire Gauge Chart

Cord	Wire Gauge
Length		Size	Amperage
0 to 100 ft.
		12 ga.	1 Up to 20 amp draw
		10 ga.	2 Up to 30 amp draw
0 to 100 ft.
		8 ga.	Up to 40 amp draw
0 to 100 ft.

1.When amperage exceeds 20 amp; a 12 gauge extension cord should not be used for long distances.

2.When amperage exceeds 30 amp; a 10 gauge extension cord should not be used for long distances.

electrocution of workers who are repairing the electrical lines.

To avoid back feeding of electricity into utility systems, a double-throw transfer switch must be installed between the generator and utility power. The Double-Throw Transfer Switch should be installed by a licensed electrician and in compli- ance with all state and local electrical codes. (When installing a Double-Throw Transfer Switch, a minimum of 10 gauge wiring must be used.)

The electrician should also install a sub-panel to isolate the circuits you would want to use during an emergency or electrical power outage. Your generator will not be large enough to handle the load of all the lights, appliances, TV, etc. at one time. To select which items to run during the electrical power outage, see Wattage Calculation section in this manual.

OTHER LOOSE PARTS

1.Oil is supplied, see engine operator’s manual for correct procedure to add oil and fuel to engine.

2.The locking plugs maybe used when needed or required.

The locking plugs are to be installed and/or used in

accordance with appropriate local electrical code regulations. Refer to instructions enclosed with each plug for proper installation.

3.12V DC cables to be used with the 12V DC outlets. See Operation section.

IMPORTANT: Before any attempt to start your generator be sure to check engine oil (See Engine Operator's manual)

12 — ENG