90538205 PC700D & PC650HD 7/2/08 12:29 PM Page 8
•To select forward rotation, push the forward/reverse slider (3) to the left (when viewed from the chuck end).
•To select reverse rotation, push the forward/reverse slider (3) to the right (when viewed from the chuck end).
SELECTING THE DRILLING MODE PC650HD (FIGURE G)
•For drilling in masonry, set the drilling mode selector (5) to the “hammer symbol” 
position.
•For drilling in other materials and for screwdriving, set the drilling mode selector (5) to the “drill symbol” 
position.
TWO-GEAR SELECTOR PC650HD (FIGURE H)
•For drilling in steel and for screwdriving applications, turn the
•For drilling in materials other than steel and when using smaller diameter bits, turn the
SETTING THE DRILLING DEPTH PC650HD (FIGURE D)
•Slacken the side handle (9) by turning the grip counterclockwise.
•Set the depth stop (8) to the desired position. The maximum drilling depth is equal to the distance between the tip of the drill bit and the front end of the depth stop.
•Tighten the side handle by turning the grip clockwise.
SWITCHING ON AND OFF
•To switch the tool on, press the variable speed switch (1). The tool speed depends on how far you press the switch.
•For continuous operation, press the
•To switch the tool off, release the variable speed switch. To switch the tool off when in continuous operation, press the variable speed switch once more and release it.
: The drill should only be locked ON when it is held stationary in a drill press stand or other means; NOT BY HAND! Never unplug the tool with the locking feature engaged. To do so will cause the tool to start immediately the next time it is plugged in.
DRILLING
•Always unplug the drill when attaching or removing accessories. When attaching accessories in the drill chuck, it is important to securely tighten the chuck using all three holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
•Use sharp drill bits only.
•Support and secure work properly, as instructed in the Safety Instructions.
•Use appropriate and required safety equipment, as instructed in the safety instructions.
•Secure and maintain work area, as instructed in the safety instructions.
•Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit from slipping out of it.
•Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not so much as to stall the motor or deflect the bit.
•Hold the drill firmly with both hands to control its twisting action. One hand should be placed on the side handle.
•Drills equipped with a side handle must use the side handle.
•DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN RESULT.
•Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part of the hole.
•Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
8
