Porter-Cable PN650 EMPLOYER’S Responsibilities, Functional Description, Foreword, Power Source

EMPLOYER’S RESPONSIBILITIES

DANGER: Employer must enforce compliance with the safety warnings and all other instructions contained in this manual.

Keep this manual available for use by all people assigned to use this tool.

For personal safety and proper operation of this tool, read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. Read and follow all of these instructions carefully.

FUNCTIONAL DESCRIPTION

FOREWORD

Porter-Cable Model PN650 is a heavy duty pneumatic palm nailer. The tool, as supplied, is assembled with the magnetic nail guide for driving 6d to 16d common flat head nails. Other guides included in the kit are the finish nail guide (C) Fig. 13 for 1-1/4"(3d) to 2-1/2"(8d) finish nails, standard guide (I) and bushing (H) for 4" (20d) to 6-1/2" (70d) common nails/spikes. A hammer head attachment (D-G) is also supplied, which is capable of various other driving tasks not suitable for the other three guides.

B A

CJ DI

F H

E

G

Fig. 13

A- Palm Nailer

B- Glove

C- Finish Nail Guide

D- Hammer Base

E- Hammer Head

F- Hammer Guide Bushing

G- Hammer Sleeve

H- Standard Guide Bushing

I- Standard Guide

J- Open End Wrench 24mm x 30mm

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated pressures between 50 and 120 PSI (Pounds per Square Inch)(3.4 to 8.3 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible (within 15 ft/4.6 m is ideal).

All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an in-line oiler is not available: place five or six drops of Porter-Cable Air Tool Oil into the tool’s air inlet at the beginning of each workday.

The tool is equipped with a 1/4" male “quick connector”. The tool must always be connected to the air supply with a coupling such that all pressure is removed from the tool when the coupling is disconnected.

5