FINISH NAIL GUIDE ASSEMBLY
1.
WARNING: Disconnect tool from air supply.
2.The finish nail guide (A) Fig. 17, for driving
Fig. 17 |
| C |
|
A
B
A B
Fig. 18
3To install finish nail guide, lay tool on its cap with nail guide pointing upward. Loosen and remove the magnetic nail guide bushing (B) Fig. 15 using the 24mm open end wrench supplied.
4.Lift the magnetic nail guide (A) Fig. 15 off of the driver blade and place it in the carrying case.
5.Remove the plastic plug (C) Fig. 17 from the finish nail guide. Take care not to allow the drive pin and spring to fall out of the bore of the finish nail guide. Slide the finish nail guide (A) Fig. 18 over the driver blade.
6.Slide the magnetic nail guide bushing (B) Fig. 18 over the finish nail guide and screw it into the housing using the 24mm open end wrench and tighten as securely as possible.
STANDARD NAIL GUIDE ASSEMBLY
1.
WARNING: Disconnect tool from air supply.
2.Standard (spike) nail guide has a ¾" ID and is used for driving large 4" (20d) to
3.To install standard (spike) nail guide and bushing, lay tool on its cap with nail guide pointing upward. Loosen and remove the magnetic nail guide bushing (B) Fig. 15 using the 24mm open end wrench supplied.
4.Slide the magnetic nail guide (A) Fig. 15 off of the driver blade.
5.Place both the magnetic nail guide and bushing in the carrying case for safe storage.
6.Take the standard nail guide (A) Fig. 19 and guide bushing (B) from the carrying case.
7.Slide the standard nail guide (A) Fig. 20 over the driver blade and inside of the spring coils. Slide the standard nail guide bushing (B) over the driver blade and spring. Screw the standard nail guide bushing into the tool housing and tighten as securely as possible using the 24mm open end wrench.
7
