MODELS WITH SPARK PLUG TO REAR OF MOWER
To prevent cable damage, the cable must be attached to the side of engine, away from the muffler.
•Above the muffler, locate the hole in en- gine shroud. Install supplied cable clip on cable and assemble to side of engine with supplied hex head screw. Tighten securely.
MODELS WITH TECUMSEH ENGINE
•Straighten cable and find the end with the small tapered plastic fitting.
•Hook the “Z” bend fitting on inner wire of cable into hole as shown.
•Align the tapered end of the plastic fitting with the hole in the mounting bracket and push in until fitting snaps into place.
•Route cable under crossbar portion of lower handle and up to upper handle control bar.
•Hook “Z” bend fitting on inner wire into hole in control bar (See “ASSEMBLE CABLES TO UPPER HANDLE” in this manual).
TECUMSEH ENGINES
WITH SPARK PLUG FORWARD
Mounting bracket
Small plastic fitting
“Z” Fitting
TECUMSEH ENGINES
WITH SPARK PLUG REARWARD
“Z” Fitting
Small plastic
Mountingfitting bracket
MODELS WITH BRIGGS & STRATTON QUANTUM ENGINES
•Hook the “Z” bend fitting on inner wire of cable (end with tapered plastic fitting) into hole in brake lever of engine. Cor- rect brake lever to use is determined by position of spark plug on your mower
- forward or rearward.
•Position the tapered plastic fitting into the mounting bracket on engine. Snap fitting into place.
•Route cable under crossbar portion of lower handle and up to upper handle control bar.
•Hook “Z” bend fitting on inner wire into hole in control bar (See “ASSEMBLE CABLES TO UPPER HANDLE”).
Brake lever (rearward spark plug) | Brake lever |
| (forward spark |
| plug) |
Mounting bracket | Mounting bracket |
(rearward spark plug) | (forward spark plug) |
ASSEMBLE CABLE(S) TO UPPER HANDLE
(USE HARDWARE GROUP “F”)
•Assemble cable(s) to opposite side of upstop bracket.
•Be sure to route cable(s) underneath crossbar of lower handle.
•Position throttle control (if equipped) on outside of handle and zone control square fitting on the inside.
•Secure to handle with the
•Secure cable(s) to crossbar and lower handle with cable ties as needed.
14
